Universal Smart Charger is designed for any NiMH/NiCd battery pack from 2.4V- 7.2V with capacity > 600mAh
100-240V AC input for world wide power support.
Ideal for 4.8V - 7.2V NiMH battery packs of RC flight, RC car, Bikelighting and rechargeable flashlight.
It can alse be use as a battery charger module for any DC device
It is a very smart charger. Just plug it in and wait for battery to charge
Automatically detect battery pack's voltage, Red LED will be on during charging.
Automatically cut-off by negative delta V when battery pack is fully charge.
When battery is fully charge, LED will change from Red to Orange color.
Two current levels 0.6A and 1.2A, are selectable by a switch
For battery pack less than or equal to 1200mAh, please switch charging rate to 0.6A
For battery pack over 1200 mah, please switch charging rate to 1.2 A
The fuse is installed in power line for protection of over current, short circuit & reverse polarity protection. It is easy to replace. Two extra fuse is included .
Charging time is about 4 hrs for 4500 mAh battery pack, 1.5 hrs for 1800 mAh, and 1hr for 1200 mAh.
One standard Tamiya male connector is installed with the charger.
One set of Clip adapter with a female tamiya connector included for charging any battery packs.
One connector adaptor from standard Female Tamiya to Male Mini. Tamiya for charging RC air battery packs.
Cautions:
The charger is designed for fast charging NiCD and NiMH battery packs from 2.4V to 7.2V battery. with capacity > 600 mAh.
Please don't use the charger for low capacity battery pack (600mah).
Please don't charge battery pack with voltage < 2.4V or voltage > 7.2V
Strongly suggest to use Tenergy brand high drain rate battery pack. We are not responsible for any damage cause by charging other brand battery using this charger. Please make sure polarities between charger and battery pack are match before charging the battery. Otherwise wrong polarity may burn the fuse and damage the charger. The charger is designed for indoor use only. The charger should be horizontally position and work in well ventilated condition. Avoid it being wet and keep it away from flammable/ explosive goods. Cut off the power supply before connecting or disconnecting the charger with batteries.
Don't try to disassemble the charger because of the high voltage inside, danger!!!
