Results for 'Polymer Li Ion Battery 3 6V'

Features and Benefits

• Protection Circuit Board for 3.6V Li-ion and Li-polymer battery pack
  
• Designed for 3.6V Li-ion or Li-Polymer battery
  
• Prevent 3.6V Li-ion or Li-polymer battery from over-charging, over-discharging and from discharging current more than 3.5A.
  

Because of the very high energy density, Li-Ion Battery pack must be connected to a protection circuit module to prevent accidental battery explosion caused by over-charging or over-discharging.

Features and Benefits

• Protection Circuit Board for 3.6V Li-ion and Li-polymer battery pack
  
• Designed for 3.6V Li-ion or Li-Polymer battery
  
• Prevent 3.6V Li-ion or Li-polymer battery from over-charging, over-discharging and from discharging current more than 3.5A.
  

Because of the very high energy density, Li-Ion Battery pack must be connected to a protection circuit module to prevent accidental battery explosion caused by over-charging or over-discahrging.

Features and Benefits

• 3 cell Lithium Polymer 700mAh battery pack.
• 15C continuous discharge rate of 10.5 amps with 14 amp bursts in accordance with our "Real Flight Rating" method.
• Maximum charge rate 0.7 Amps.
• Dimensions: 21mm x 36mm x 68mm
• Weight: 65 grams
• Please see our "Real Flight Rating" method that describes more specific use of "burst" discharge rates with our Li-Poly cells.

• This 2500mah Lithium Polymer pack fits all Futaba, Hitec, Airtronics and JR Transmitters that use the "Square" pack.
• It comes with an "RCY" type connector that is likely to work with the connector on your transmitter.
• If it doesn't mate up, you can cut the connector off of your existing battery and splice it to the wires on our pack.
• Airtronics radios cannot be charged using the charging receptacle located on the outside of the radio.
• Maximum discharge rate 10 Amps.
• Maximum charge rate 2.5 Amps/charge at 1 Amp for longer battery life.
• Dimensions: 30mm x 30mm x 100mm